Ypatingas Resistance vandeniui - D4 klasė. More resistant than ordinary wood adhesive. Open time is up to 30 minutes.\n\nKLEIBERIT 506.0 is a low viscosity, moisture curing polyurethane adhesive for bonding porous and non-porous materials where extreme bonding strength and resistance to harsh environmental conditions are required. Due to the low viscosity of these adhesives, they are easy to apply when gluing large areas. The 30* minute open time of the adhesive will allow you to accurately connect even complex products that require time and care to be glued. Minimum pressing time 90* minutes.\n\nPolyurethane adhesives are used for outdoor and indoor operations when gluing various materials, such as wood, chipboard (MDP), wood dust board (MDF), wet construction wood, concrete and other construction mineral materials, polystyrene, stone, or metals.\n\nUse:\n\nWear gloves when using adhesive. The adhesive can be applied directly from the bottle and, if necessary, spread with a notched trowel or brush. Close the package tightly immediately after use. This will preserve the adhesive for longer. The adhesive is applied to one of the surfaces to be bonded and the materials are strongly compressed ensuring good contact and a thin adhesive joint. You have up to 90* minutes to apply the glue before pressing the parts. The minimum pressing time for gluing straight parts is 90* minutes. The adhesive expands as it hardens. Hardened glue is easy to process and sand. Maximum bonding strength and resistance is achieved after 7 days.\n\nCleaning:\n\nUncured adhesives and tools can be cleaned with a cleaner KLEIBERIT 820.0. Hardened adhesive can be softened with a cleaner KLEIBERIT 822.5\n\n